How to Change Jeep Engine Oil Pressure Sensor

How to Change Jeep Compass Engine Oil Pressure Sensor

Jeep Compass (2014) Symptoms: low oil pressure light illuminates on cold start (mornings) or when vehicle has been sitting for few hours. Restarting the engine solves the problem and oil pressure light goes off. Until it illuminates again on next cold start.

Do not drive your used car with low oil pressure light on, unless you are 100% sure its a sensor problem. If low oil pressure is caused by a failed oil pump or blocked oil passages severe engine damage will occur in a short period of driving.

Oil pressure was measured and was within normal parameters. Low oil pressure light stays on. Problem was narrowed down to oil pressure sensor failure.

Jeep Compass Oil Pressure Sensor Location

Oil Sensor on Jeep Compass (2014) is located in front of the engine, on top of Oil Filter Housing (image below).

Jeep compass oil filter housing and oil pressure sensor as viewed from underneath the engine.
Jeep Compass Oil Pressure Sensor Location

How to Change Jeep Compass Oil Pressure Sensor: Jeep Oil Pressure Sensor removal: initially remove oil filter housing to gain access to Compass oil pressure sensor.

Tools: 13 mm socket and ratchet for oil housing bolts. Oil sensor removal socket or a 1-1/16 socket.

Jeep Compass Oil Filter Housing Removal

Remove oil filter by unscrewing it counterclockwise. Remove four 13mm bolts of oil filter housing. Bottom two bolts of oil filter housing are easy. Top two bolts are hidden and need more effort.

Jeep Compass Oil filter housing and 13mm bolts holding it in place.
Jeep Oil filter housing

Jeep Compass oil pressure sensor is located behind oil filter housing.

Jeep Compass with oil filter housing removed revealing oil pressure sensor location.
Compass oil pressure sensor location

Unplug electrical connection, use a flat screwdriver to push safety tab out (Red arrow, picture below). Press down on center lock tab on connector while pulling to unplug it (Blue arrow).

Jeep compass Oil pressure sensor electrical connection plug next to engine block.
Jeep Compass Oil pressure sensor plug

Use socket to unscrew old oil pressure sensor and install new pressure sensor.

Jeep Compass Oil Pressure Sensors, old sensor and new sensor side by side.
Jeep Compass Oil Pressure Sensor

How to Install Compass Oil Pressure Sensor: Tighten new oil pressure sensor, plug oil pressure sensor electrical connection. Install oil filter housing and oil filter.

Replacing oil pressure sensor in this case fixed oil pressure trouble light problem on cold start.

(If you are also looking for a fast and easy solution to sell your car, more here on “How To Sell Your Car Fast In Ontario”. )

Comments: If you have any questions or suggestions related to this post or Used Car Toronto in general, don’t hesitate to use comment section below.

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *